| |
Technical data: |
Tl.-Id.2063183
For simultaneous upper and lower radius/flush-
milling of overhanging edge materials on straight
edges as well as cambered workpieces with
inside and outside radius.
Feeding with stopper rails for straight
edges and centric start-up rings for
sized parts.
Pneum. motor-spreading device for sized parts.
Fine adjustmen top and bottom.
Upper and lower milling motor pivoted tracingly
independently from each other.
milling works only allowed in counter direction!
Standard equipment:
- double-tracing rollers for straight workpieces
- single-tracing rollers for sized parts
- blowing-off device on top for milling chips
- static frequency transformer 200 Hz,
incl. motor braking
In case of voltage fluctuations bigger than +/- 10 %
a voltage stabilizer has to be built in on site.
Machine deliveries for EU-countries safety-related
equipped according to EC-rules 89/392/EWG, appendix I.
workpiece thickness (radius milling) about 16 - 55 mm
workpiece thickness (chamfer milling) about 12 - 55 mm
workpiece width min. about 30 mm
workpice width min. about 35 mm
inside radius min. about 35 mm
(depends on edge radius and
workpiece contour)
edge thickness max. about 3 mm
milling tool 2 x WPL-radius cutter r = 3 mm
diam.67 x 21 x 16 mm, t = 4
milling motors 2 x 0,35 kW, 11800 rpm
electrics 400 V - 3 Ph. - 50 Hz
electrical connected load 0,7 kW
pneumatic connection 5 bar
extraction 1 x diam. 80 mm
working height 900 mm
length 1250 mm width 850 mm
height 1500 mm
weight 250 kg
|
|
